![]() follows: Misfire: READY, Catalyst: READY, EGR: READY, Fuel System: Ready. Idle for 5 minutes, then shut the engine and leave the vehicle off for 10 minutes. to have one monitor not ready as long as the others pass and there is no. Repeat idle and acceleration to 30-40 mph five times. Smoothly accelerate and maintain a speed between 30 to 40 mph It means your Onboard Diagnostic System (OBD II) has NOT completed all of its self-test monitors that keep an eye on the performance of your emissions control. Smoothly accelerate and maintain a speed above 25 mph for 2 minutes. Trace 1: Standard Type – Make sure that your fuel level is between 50% and 85% full.įrom 6-8 hours of the vehicle being off (cold soak), idle for 5 minutesĭrive in city traffic naturally with stops and acceleration for 5 minutes. Smoothly accelerate and maintain a speed between 40 to 60 mph for 2 minutes.ĮGR System Monitor Drive Trace – Electronic Smoothly accelerate and maintain a speed between 30 to 45 mph for 2 minutes.ĮGR System Monitor Drive Trace – Vacuum controlled Smoothly accelerate and maintain a speed above 20 mph for 2 minutes. Smoothly acceerate and maintain a speed between 40 to 60 mph for 8 minutes. Note: Original 1996 Chrysler vehicles do not maintain OBD2 readiness after engine shutdown, however this is a fix that is available at a dealer.įor all drive cycles, make sure the check engine light (MIL) is off. If the MIL does not flash and remains fully lit, you are ready to go to the smog station. if the evap monitor is not ready, verify that your fuel cap is tight and the level of fuel is between 1/4 and 3/4 full.If the MIL flashes for 10 seconds, and then returns to being fully illuminated, the OBDII sensors are NOT READY and you need to complete the drive cycle.After 15 seconds, one of two things will happen.The check engine light f the (MIL) will turn on for 15 seconds.Turn on the ignition to ON, but do not start the engine. You need to find out why the kraftwerks kit is messing with the evap. ![]() At A Star Smog, we will use an OBDII scanner to conduct a smog precheck. In order to determine if your Jeep, Dodge, or Chrysler vehicle is ready for an emissions test, you can either use an OBDII scanner or, if one is not available, check the MIL (check engine light). ![]()
0 Comments
Leave a Reply. |